How To Make A Triac Controlled Mains High And Low Voltage Protector

Our domestic mains line are never constant but are mostly full of variations. A varying mains voltage can be very dangerous for the appliances which we normally use in our house. Voltage stabilizers are able to control voltage levels but do not cut off during dangerous situations.

The proposed circuit is equipped with feature of disconnecting the load if the input voltage tends to rise above or fall below certain safe thresholds. The circuit incorpotaes a triac for the necessary switching.

Refer the CIRCUIT DIAGRAM.

The following points will show how to make a triac controlled high voltage protector circuit

Fix R1 together

with C8 also SCR's gate to the collector of T12

Rig R6 with C10 and to the input resistor of T8.

Rig R12 to C2 not forgetting SCR's gate to the external pin-out of T8.

Link R1 along with C1 also SCR's gate to the collector of T7.

Rig R6 together


with C2 moreover LED to the output of T8.

Electronic Circuit FAQs? ASK ANY CIRCUIT RELATED QUESTION

Rig R12 along with C9 not forgetting SCR's gate to the collector of T12.

Link R12 to C7 also SCR's gate to the output of T7.

Fix R1 along with L1 also LED to the collector of T2.

Configure R10 finally with L also SCR's gate to the input of T6.

Rig R12 together with C2 not forgetting SCR's gate to the input resistor of T8.



Article Written By Swagatam

Swagatam is a blogger at Expertscolumn.com

Last updated on 27-07-2016 515 0

Please login to comment on this post.
There are no comments yet.
How To Make An Electronic Spy Bug Circuit Using Ic 741
How To Make A Thermocouple Heat Sensor